Cycle Bike Seat Assembly

Have more questions? Submit a request

Seat Assembly & Tighten Seat for Cycle Bikes

Here is a quick guide instructing you on the assembly of your seat clamp. If you have any
problems you can e-mail support@sunnyhealthfitness.com.

The bike’s seat will be assembled as shown to the right. The clamp in the center is secured tightly. This is done to make sure the bolts do not come apart during shipping. However, you will need to slightly loosen the nuts on the ends in order to place the center clamp around the bike stem. DO NOT REMOVE nuts from the clamp otherwise it may disassemble. 

mceclip0.png

mceclip1.png

If the bike’s clamp arrived unassembled, or if you have accidentally loosened the bolts resulting in the clamp to disassemble, take a look at the picture below for easy assembly. The picture below will show you the order in which each of the pieces need to be reassembled. You will need to place them back in this order in order to reattach your clamp back to the bicycle seat. 

mceclip2.png

STEP 1: Begin by inserting the screw (2) through the clamp (1) piece. Place the screw over the bike’s brace. (see right photo) It should sit nicely on the bikes braces.

mceclip3.png

STEP 2: Take the ridges (5) and place the teeth alongside the clamp (1) . Notice that they have grooves that will lock onto the bike’s seat brace. (see left photo) These pieces should sit between the bike’s braces. For a better photo, view step 2 continued. 

mceclip4.png

STEP 2: (Continued): This is usually the trickiest part of assembly. The ridge pieces (5) have grooves that will fit the brace. Here is another photo for reference. Once you have correctly assembled the ridges to the clamp, they should sit nicely over the bike’s brace. This way you can easily screw in the groove caps and nuts for finished assembly.

mceclip5.png

STEP 3: Now place the final groove (4) pieces outside the bike’s seat brace and lock together with the nuts (3). Make sure to screw these pieces together tightly for a secure fit. You have successfully put your seat’s clamp back together! Revisit page 1 to place the seat on the bike’s stem. 

mceclip6.png

 

For more information, please see video below:

Articles in this section

Was this article helpful?
0 out of 2 found this helpful
Share

Comments

0 comments

Please sign in to leave a comment.