Treadmill Power Switch Replacement

How to replace the Power Switch on the treadmill 

 

Here is a quick guide instructing you on the replacement of the treadmill power switch. 

 

STEP 1: As a safety precaution, unplug the unit from the wall outlet and flick the power switch on and off a few times to release any electricity.

Step_1.JPG

 

STEP 2: Remove the motor cover screws using a Phillips screwdriver. 

Step_2.jpg

STEP 3: Disconnect the wires from behind the power switch.

(Note: Take a picture of the wires prior to disconnecting to use as a reference when reconnecting)

Step_3.JPG

STEP 4: Push the side of the power switch to remove it from the mainframe. 

(Note: Use a flathead screwdriver to help you pry the original power switch out)  

Step3__2_.JPG

STEP 5: Install the new power switch into the mainframe by squeezing the side tabs and pushing the switch firmly into the mainframe.

Step5.JPG

STEP 6: Reconnect the wires to the new power switch. 

Step6.JPG

STEP 7: Once all the wires are reconnected, plug in the unit to the wall outlet and turn the power switch on. The power switch should light up red.

power_swith_step7.png

 

For more information, please see the video below: 

Articles in this section

Was this article helpful?
1 out of 1 found this helpful
Share

Comments

0 comments

Please sign in to leave a comment.