Carlos - Customer Relations

  • Total activity 124
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 2
  • Subscriptions 50

Activity overview

Latest activity by Carlos - Customer Relations
  • Carlos - Customer Relations created an article,

    Treadmills: Overheating and Burning Odor

    Overheating can be caused by various factors, below is a quick guide that will assist you with the proper steps to check in case your unit begins to overheat.     1. Check Ventilation: Ensure that ...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    SF-RW5713 Tangled Mesh Belt

    How to untangle the mesh belt on your rower Here is a quick guide instructing you on the proper procedure to successfully untangle the mesh belt on your rower.   STEP 1: Pull out all of the mesh b...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    Cycle Bikes: Belt vs Chain Driven Models

    It is difficult to say which is better, the answer depends on which of the two suits your personal workout preferences. Below is a quick guide outlining key points to assist you in making the best ...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    Clearing the "OIL" reminder message on your treadmill

    How to clear the "01L" message on your treadmill Here is a quick guide to assist you in the proper procedure to clear the "oil" message on your treadmill after lubricating the running deck.    Your...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    SF-B1877 Bearing and Middle Axle Replacement

    How to replace the bearings, middle axle, and hardware on the unit. Tools required for this task are a socket wrench, crank puller tool, snap ring pliers, mallet, and screwdriver.   Here is a quick...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    Treadmills: E2 Error Code

    The error code can be associated with the unit not having the proper amount of voltage input. The incoming voltage is lower than 50% of the required voltage. Here is a quick guide instructing you o...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    Treadmill Not Turning On

    If your unit is not starting, here is a quick guide to assist you. Please follow these few steps that should assist you with the issue at hand.    Step 1: Is the unit plugged directly into the wall...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    Como Lubricar una Caminadora

    NOTA IMPORTANTE: Deberá lubricar su caminadora antes del primer uso. ADVERTENCIA: Siempre desenchufe la caminadora de la toma de corriente antes de limpiar, lubricar o reparar la unidad.   Es impor...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    Cycle Bike Noise Troubleshooting

    Here is a quick guide instructing you on the proper procedure to troubleshoot the noise the unit is making while in use. Below I have provided 6 steps to isolate the noise on your bike. This will n...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes
  • Carlos - Customer Relations created an article,

    SF-T7917 Converting Miles to Kilometers

    How to convert the unit of measurement from miles to kilometers on your treadmill.    Here is a quick guide instructing you on the proper procedure to successfully convert miles into kilometers.   ...

    • Edited
    • 1 follower
    • 0 comments
    • 0 votes