SF-RB4616S Belt Replacement

How to Replace The Belt on Your Recumbent Bike

Here is a quick guide instructing you on the correct process to successfully replace the belt on the recumbent bike. 


STEP 1: Remove the pedals using a #15 open wrench. When removing the Right pedal you will turn counterclockwise. To remove the Left pedal you will turn clockwise


STEP 2: Remove the covers using a Phillips screwdriver.

Place the crank arm at the 2 o'clock position on either side to remove the covers.


STEP 3: Remove the belt by placing your hand on the crank and rotating clockwise, while the other hand pulls on the belt towards you. Please go slowly and be careful not to pinch your fingers. 


STEP 4: Install the belt in the correct position as shown below. You can use a zip tie to assist you with this process.

Place the Zip Tie                                       Zip Tie holds the belt                                      Remove the Zip Tie               


STEP 5: The Belt is installed.



For more information, please see the video below:









Articles in this section

Was this article helpful?
1 out of 3 found this helpful



Article is closed for comments.