SF-RB423034 Smart Magnetic Recumbent Bike: Hand Cycle Disassemble and Reassemble

Comprehensive Guide 

Welcome to our step-by-step maintenance guide for the SF-RB423034 model. This article is designed to walk you through the essential repair and reassembly procedures for your equipment, covering:

Component Removal: Detailed instructions on how to remove various parts including the E-shape circlip using snap pliers, the hand cycle, tension knob, spring washer, crank cover, and flat washer. We also guide you through the removal of the adjustment knob, upper and lower compressing sheets, and the small crank.

Installation Procedures: Step-by-step guidance on reinstalling the small crank, upper and lower compressing sheets, adjustment knob, flat washer, crank cover, and E-shape circlip. We’ll also show you how to properly place the foam and C-clip.

Each section is carefully time-stamped for quick reference, ensuring you can efficiently perform maintenance and reassembly tasks on your equipment.

TABLE OF CONTENT

0:05 | How to remove the E-shape circlip using the snap pliers

0:12 | How to remove the hand cycle

0:24 | How to adjust the tension knob

0:34 | How to remove the spring washer

0:47 | How to remove the crank cover and flat washer

1:02 | How to remove the adjustment knob

1:24 | How to remove the upper compressing and sheet

1:36 | How to remove the lower compressing

1:44 | How to remove the small crank

2:07 | How to install the small crank

2:21 | How to install the upper and lower compressing and sheet

2:56 | How to install the adjustment knob

3:14 | How to install the flat washer and crank cover

3:30 | How to install the E-shape circlip using the snap pliers

4:00 | How to place the foam and C-clip

For more information, please see the video below: