Simple Bearing Replacement

How to replace the simple bearing 

 

Here are the steps required to properly replace the simple bearing on your recumbent bike.

 

STEP 1: Remove the Nylon Nut (part 59L and or 60R) using an adjustable wrench. 

simple_bearing_step_1.png

 

STEP 2: Begin to unthread the pedal. Hold the hardware as they will fall when the pedal bolt is removed. simple_bearing_step_2.png

 

STEP 3: Push on the backside of the bearing towards you to remove the bearing. 

simple_bearing_step_3.png

 

STEP 4: Once the bearing is replaced, apply pressure to insert the bearing into the connecting rod.

simple_bearing_step_4.png

 

STEP 5: Reinstall the pedal and hardware into the connecting rod. 

simple_bearing_step_5.png

 

STEP 6: Once the pedal bolt is installed, tighten the Nylon Nut to finish the assembly. 

simple_bearing_step_6.png

 

For more information see the video below: 

 

 

 

 

Articles in this section

Was this article helpful?
2 out of 2 found this helpful
Share

Comments

0 comments

Article is closed for comments.