SF-T7718 Device Holder Replacement

How to Replace the Device Holder on Your Treadmill 

 

Here is a quick guide instructing you on the device holder replacement process.

 

STEP 1: Remove all stickers. 

A black rectangular object with red arrows

Description automatically generated with low confidence

 

STEP 2: Remove all the screws.

A picture containing person, indoor, table, electronics

Description automatically generated

 

STEP 3: Hold the back cover and carefully retract it. 

A picture containing person, holding, indoor, device

Description automatically generated 

 

STEP 4: Carefully disconnect the wire.

A picture containing person, electronics, indoor, wall

Description automatically generated A picture containing person, electronics, indoor, oven

Description automatically generated 

 

STEP 5: Hold the cover in an upright position and remove the two screws. Make sure that you only remove the two screws that are holding the lock in place. 

A hand holding a black rectangular object

Description automatically generated with low confidence A person holding a screwdriver

Description automatically generated with medium confidence 

 

STEP 6: Hold and remove the lock. 

A picture containing mirror, person, indoor

Description automatically generated 

 

STEP 7: Remove the broken device holder. 

 

 

STEP 8: Install the new device holder. 

A picture containing person, wall, mirror, indoor

Description automatically generated 

 

STEP 9: Install and adjust the lock.

A picture containing person, indoor, holding, using

Description automatically generated A picture containing person, indoor

Description automatically generated 

 

STEP: 10 Once the lock is in place, put the screws back.

A picture containing person, holding, indoor

Description automatically generated 

 

STEP 11: Test the device.

A picture containing gate, bus

Description automatically generated 

 

STEP: 12 Connect the wires and attach the back cover. Make sure you do not pinch the wire when reinstalling the cover, especially in the circled area. 

A picture containing person, indoor, electronics, wall

Description automatically generated A picture containing person, wall, indoor

Description automatically generated 

 

STEP 13: Put all the screws on the back cover. 

A person holding a screwdriver

Description automatically generated with low confidence 

 

STEP 14: Replace all of the stickers.

A picture containing person, wall, whiteboard, office supplies

Description automatically generated 

 

 

For more information, please see the video below:

 

 

 

 

 

 

Articles in this section

Was this article helpful?
0 out of 0 found this helpful
Share

Comments

0 comments

Article is closed for comments.