How to replace the left side handle covers on the treadmill.
Here is a quick guide instructing you on the proper procedure to successfully replace the handle covers on the left side rail.
STEP 1: Using a Phillips screwdriver, remove the screws holding the handle cover.
STEP 2: Remove the bottom cover.
STEP 3: Unplug the signal connector.
(If not replacing the Safety Key Plug, please skip steps 4, 5, and 10)
STEP 4: Using a Phillips screwdriver remove the screw.
STEP 5: Carefully unplug the wires from the base and install the new one.
STEP 6: Plug the connector into the new handlebar control.
STEP 7: Install the handle control to the tube.
STEP 8: Once it is in place, make sure that no wire is pinched between the tube and handle. Also, move the safety key base to the center.
STEP 9: Place the bottom cover and secure it with the screws using the Phillips screwdriver.
STEP 10: Secure the safety key base.
For more information, please see the video below: