Stepper Cable Installation Guide

How To Install Your Stepper Cable


STEP 1: With the pedometer facing you, lift up the pedal to loosen the stepper cable. 

 STEP 2: With the pedal raised, place the loosened cable onto the pulley and push down on the left pedal to tighten the cable around the pulley.

(Note: when the cable is properly installed, one pedal will be upright when the other is descended)

STEP 3: Turn the pulley knob at the front of the machine clockwise to adjust the step height to your preference. (Note: some steppers have the height adjustment knob at the bottom of the machine)


For more information, please see the video below:

Articles in this section

Was this article helpful?
1 out of 7 found this helpful



Article is closed for comments.