SF-E905: How To Remove The Covers

How To Remove The Covers

 

Step 1: Remove the nylon nuts (Part numbers 40L and 40R) from each side using a wrench or spanner tool. (Remember the left side will be reverse threaded and will need to be turned counter-clockwise to be removed).

mceclip0.jpg

Step 2: Remove the Hinge Bolts (Part numbers 19L and 19R) from each side using an Allen wrench. (Remember the left side will be reverse threaded and will need to be turned counter-clockwise to be removed).

905ArticleStep2.JPG

Step 3: Remove the screws (Part numbers 95 and 97) along the edge of the belt covers on both sides.

905ArticleStep3.JPG905ArticleStep3-2.jpg

Step 4: Once all screws are removed, you can slide the belt covers off over the crank arms (Part number 49). It is recommended that you adjust the crank arms to point upward and slightly back and then slide the covers upwards for the easiest removal.

905ArticleStep4-2.JPG905ArticleStep4.JPG

For more information, please see the video below (cover removal from 0:00 to 2:55):

 

 

Articles in this section

Was this article helpful?
1 out of 1 found this helpful
Share

Comments

0 comments

Article is closed for comments.